Additional Functions And Individual Settings; Information On The Display; Safety Instructions - Bosch WVH28420GB Operating Instructions Manual

Additional functions and Individual settings

Finish in
When you select a programme, the respective programme duration is displayed. You can delay
the start of the programme before it begins. The finish-in time indicates when the programme will
be finished. It can be set in hour increments up to a maximum of 24 h.
Press and hold the Finish in button until the required number of hours is shown (h=hour).
Select Start/Pause , the door is locked.
Spin speed
You can change the indicated spin speed. The maximum spin speed which can be selected
depends on the chosen programme. If
Dry
You can activate, deactivate and set the drying function by touching this option button. Mode
of washing and drying without interruption is auto dry only; when single drying programme
is selected, you can choose auto dry, or time dry with desired drying time.
Additional functions
Prewash
Water Plus
Less Iron
Intensive
Start/Pause
For starting or pausing the washing/drying programme.
Signal volume (for button signal and information signal)
1. Start signal mode
Set to
Button signals
2. Set volume for ...
Set volume*
*If required, set repeatedly
Childproof lock
Programme will not be changed by accidental operation.
To activate the childproof lock:
– After the programme starts or finish in time being activated
Finish in button for 5 seconds.;
– Release when the symbol lights up. If button signal is on, an acoustic signal will be heard.
When the programme ends, the Start/Pause
deactivate the childproof lock.
To deactivate the childproof lock:
– Touch the Finish in button until the
– Release the button.
symbol flashes if the programme has been changed while childproof lock is activated. If the
childproof lock is deactivated while the programme selector is in a different position from when
the childproof lock was activated, the running programme will be halted.
is selected, the load is held in the rinsing water.
See also Programme overview Page 7
ewash at
For heavily soiled laundry. Pr max. 30°C.
High water level to achieve better rinse result.
Special spin sequence with subsequent fluffing. Gentle final
spin – residual moisture in the laundry increased slightly.
Extends the washing time for a more intensive washing
of heavily soiled items.
1 step Press and 1 step
clockwise hold clockwise
Information signals
direct
1 step Set volume*
clockwise
Page 10 , press and hold the
indicator remains on to remind you to
symbol turns off.

Information on the display

Page 8
other displays
Release

Safety instructions

– Read and follow the operating and Installation and maintenance instructions and all other
information enclosed with the washer dryer.
– Retain documents for subsequent use.
Risk of electric
shock
Set to
Risk of death
Risk of suffocation
Risk of poisioning – Keep detergents and care products out of the reach of children.
Risk of explosion
Risk of injury
10
Please close the door immediately because of rising water level.
In pause status and are displayed alternately.
Door is locked for safety reasons (water level and/or temperature are too high).
For washing programme: In pause status,
alternately. If you need to open the door, wait for the temperature to drop or drain
the water (e.g. select Spin or Drain programme).
For drying programme: If you need to open the door, wait for the temperature to
drop or set drying programme for 15 minutes to cool down the laundry.
If is frequently indicated when the drying programme ends:
– Clean the air inlet filter. Installation and maintenance instructions, Page 9
– Run the Fluff Clean (cold) programme without laundry.
Door cannot be locked/unlocked due to high temperature of the door lock. Keep
the machine switched on for about 1 minute. Then the machine can be locked/
unlocked again.
Door cannot be opened due to the high temperature after the drying programme.
The cooling down process will continue until this display disappears and the door
can be opened.
Flashing (no water supply):
Tap turned on?
Inlet filter blocked? Clean filter.
Installation and maintenance instructions, Page 8
Supply hose kinked or blocked?
Clean drain pump. Installation and maintenance instructions, Page 8;
outlet pipe/drainage hose blocked.
Hold down the (Dry) button for 3 seconds to clear this display.
– Clean the air inlet filter. Installation and maintenance instructions, Page 9
– Run the Fluff Clean (cold) programme without laundry.
Switch off the appliance, wait 5 seconds and switch it back on.
If the display appears again, call the customer service.
– Never pull out the mains plug by tugging the power cord.
– Never insert/pull out the mains plug with damp hands.
For worn-out appliances:
– Pull out the mains plug.
– Sever the power cord and discard together with the plug.
– Destroy the lock on the washer dryer door.
This will prevent children from locking themselves in and risking their lives.
– Keep packaging, plastic film and packaging parts out of the reach
of children.
– Items of laundry pretreated with cleaning agents containing solvents, e.g.
stain remover/cleaning solvents may lead to an explosion after being
loaded into the washer dryer.
Rinse items of laundry thoroughly by hand before.
– Washer dryer door may become very hot.
– Take care when draining hot detergent solution.
– Do not climb onto the washer dryer.
– Do not lean on the open washer dryer door.
– Do not touch the drum in case it is still spinning.
– Ensure that the pump cap is screwed on while the machine is running to
prevent the escape of water and contact with moving pump parts.
– If a drying programme was interrupted, the washer dryer and the laundry
may be very hot, select Intensive Dry
minutes programme to cool down the laundry, then remove the
laundry.
and are displayed
On (low water pressure):
Only information. No influence on the
programme process. The programme
duration will be prolonged.
or Gentle Dry and set 15
11