Maytag MDG28PD Installation Instructions Manual page 26

ELECTRONIC CONTROL SETUP INSTRUCTIONS
Code Explanation
J. Cd PAYMENT MODE (COIN/DEBIT OPTION)
J. Cd Both coin and debit selected. (NOT AVAILABLE)
J. C_ Coins selected, debit disabled. Press the STOP/
PAUSE keypad 3 consecutive times to change
this selection.
J._d PN models: Factory default to J._d. Debit Card
selected, coins disabled. Press the STOP/PAUSE
keypad 3 consecutive times to change this
selection.
J. Ed Enhanced Debit is self-selected when a Generation
2 card reader is installed in the dryer. The Ed option
cannot be manually selected or deselected.
(NOT AVAILABLE)
• Press the DELICATES keypad once to advance
to next code.
L. 00 PRICE SUPPRESSION OPTION
This option is either NOT SELECTED "OFF" OR
SELECTED "ON." This option causes the customer
display to show "ADD" or "AVAILABLE" rather than
the amount of money to add. (Used mainly in debit
installations.)
L. 00 Not Selected "OFF."
L. PS Selected "ON."
• Press the STOP/PAUSE keypad once to change
this selection.
• Press the DELICATES keypad once to advance
to next code.
n. CE CLEAR ESCROW OPTION
This option is either NOT SELECTED "OFF"
OR SELECTED "ON." When selected, money held
in escrow for 30 minutes without further escrow
or cycle activity will be cleared.
n. 00 Not Selected "OFF."
n. CE Selected "ON."
• Press the STOP/PAUSE keypad once to change
this selection.
• Press the DELICATES keypad once to advance
to next code.
26
Code Explanation
u. 00 COIN INCREMENT OFFSET
u. 00 This represents the hundredth increment price
offset used in Generation 2 (Enhanced Debit)
PN models. Choose from 0–4 hundredths by
pressing the WHITES AND COLORS keypad.
(NOT AVAILABLE)
• Press the DELICATES keypad once to advance
to next code.
END of SETUP PROCEDURES
EXIT FROM SETUP MODE
n PD MODELS: Reinstall access door.
n PN Models where AA1 plug was removed:
1. Unplug dryer or disconnect power.
2. Open console, reinsert jumper into AA1, and close
console.
3. Plug in dryer or reconnect power.
n PN WITH PROGRAMMING SWITCH: Turn key clockwise
and remove.
n If Service Access Code was used to enter setup mode:
From Setup Code 8, press keypad #1 for 4 seconds, wait
2 minutes without touching any keypads (without diagnostic
modes running), or power down the dryer; then reapply
power.