Ryobi PCL430 Operator's Manual page 7

ON/STANDBY/VARIABLE SPEED
See Figures 3 - 4, page 10.
 The tool is in the STANDBY position when the variable
speed dial is turned fully clockwise to "0"
NOTE: You should feel the dial click into the detent when
the dial is turned to the STANDBY position.
 To turn the tool ON, rotate the dial counterclockwise.
 Continue turning the dial counterclockwise to select higher
speeds.
 Turn the dial clockwise to decrease speed.
 Squeeze the switch trigger to begin operation.
NOTE: The tool will not start if the dial is in the STANDBY
position.
 To stop the tool, release the switch trigger. Turn the dial
fully clockwise to the STANDBY position.
NOTE: Running at low speeds under constant usage may
cause the tool to become overheated. If this occurs, cool the
tool by running it without a load and at full speed.
LED LIGHT
The LED light, located on the front of the tool, illuminates
when the switch trigger is depressed.
NOTICE:
If the LED light on the front of the tool begins flashing and
the variable speed dial is set to "0", check to be sure the
tool is not in lock-on position (depress and release the
switch trigger) and remove the battery pack. Reinstall the
battery pack to resume operation.
LOCK-ON BUTTON
See Figure 4, page 10.
This tool is equipped with a lock-on feature, which is
convenient for continuous operation for extended periods
of time.
To lock-on:
 Depress the switch trigger.
 Push in and hold the lock-on button, located on the side
of the handle.
 Release the switch trigger and the tool will continue
running.
 To release the lock, depress and release the switch trigger.
WARNING:
Battery tools are always in operating condition. Rotate the
variable speed dial to "0" when the tool is not in use or
when carrying it at your side. The lock-on button should
not be left on when the variable speed dial is on "0".
OPERATION
INSTALLING ACCESSORIES
See Figure 5, page 10.
 Remove the battery pack.
 Remove the hex key from the storage area at the base
of the tool, rotate the screw counter clockwise. Remove
the screw and washer assembly and set aside.
 Place the desired accessory on the head so that the
openings on the accessory fit on the raised parts of the
head. Reinstall the screw and washer and tighten securely.
NOTE: An adaptor may be needed to properly fit some
accessories for your multitool. If this applies to your
multitool, call 1-800-525-2579.
NOTE: Always follow the instructions for the accessory,
in addition to all instructions for this product.
 Return the hex key to the storage area.
Accessory Type
General
purpose plunge
cut blade
Segment saw
blade
Detail sanding
backing pad
Sanding sheets
7 — English
Uses
Straight cutting in wood and plastic
Flush cutting in wood and drywall
Sanding in corners and other hard-
to-reach areas
Sanding sheets in 60
80 grit (1), and 120 grit (1) are provided
for sanding in different applications
grit (1),