Gazer MMR5014 User Manual page 13

Usage
pressing MENU. Press UP/DOWN to navigate to «Auto-recording»
and select the required value, then press MENU to exit from the
settings and resume the recording by pressing SEL/REC.
ENG
6. G-sensor. The mirror features a built-in G-sensor (a three-axis
accelerometer) that traces any sharp changes in the vehicle's driving
pattern (hard braking, acceleration, and impact). Files recorded when
the G-sensor is tripped are automatically protected from deletion
through loop overwriting and stored in a separate "EVENT" folder
(can contain a maximum of 15 files) where loop overwriting also
takes place. This recording principle ensures the device's continuous
operation with no additional maintenance required – the space on the
SD card is freed up automatically.
To adapt the G-sensor to external operating conditions, the mirror
allows adjusting the sensor's sensitivity. To configure the G-sensor
sensitivity, first stop the recording by pressing SEL/REC, then press
MENU to access the settings menu. Press UP/DOWN to navigate
to «G-sensor sensitivity» and select the required value, then press
MENU to exit from the settings menu and resume the recording by
pressing SEL/REC.
7. Motion sensor. Thanks to the motion sensor, the built-in DVR
supports automatic activation of the recording mode upon detection
of motion in the frame as well as automatic deactivation of this mode
after the motion in the frame stops. To enable and configure this
function, first stop the recording by pressing SEL/REC and then press
MENU to access the settings menu. Press UP/DOWN to navigate to
the «Motion sensor» and enable/disable the function or go to «Motion
sensor sensitivity» to set the sensitivity level.
8. Parking mode. When the parking mode is activated, the built-
in DVR will continue recording up to 12 hours after ACC signal is
terminated. In this case, the screen and the status indicators will be
turned off. To enable this function, first stop the recording by pressing
SEL/REC and then press MENU to access the settings menu. Press
UP/DOWN to navigate to «Parking mode» and select for how long the
DVR will operate after the ignition is turned off.
Автотовари «130»
12