Table of Contents
Advertisement
Malfunction
Washing water is not
pumped out.
No water flows into
the device. The
detergent was not
washed in.
Start several times
with centrifugation.
The program duration
changes during the
wash cycle.
The water is not
visible in the drum
bar.
Drum jerks after
program start.
Cause and Troubleshooting
Remove unauthorized extensions to the wa-
▶
discharge hose. Connect device
Start/Refill
Press Start/Refill
▶
Strainer in the water supply is clogged.
Clean the strainer in the water supply → Page 55.
▶
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water inlet hose is not
▶
nods or clenches.
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark: When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
The program sequence is electronically optimized. This
can lead to changes in the program duration.
No error - no action required.
▶
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark: When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Foam control system will add an extra rinse if the
foam is too high.
No error - no action required.
▶
The water is below visible range.
No error - no action required.
▶
Do not fill any additional water into the appliance during operation.
▶
honeycomb.
The cause is an internal motor test.
No error - no action required.
▶
Troubleshooting NL
was not pressed.
.
61
Advertisement
Table of Contents
