Brother S-1000A-5 Basic Operation Manual page 12

1. INSTALLATION
5
0004Y
0872D
S-1000A
7. Bobbin winder
1. Push down the bobbin presser arm
(1) as far as it will go.
2. Place the bobbin winder wheel (2)
so that it pushes the belt (3) by
approximately 5 mm, and then
place the bobbin winder (4) so that
it is parallel with the belt hole in the
table.
3. Install the bobbin winder (4) to the
table with the two screws (5).
4. Pull the bobbin presser arm (1)
back and check that there is
approximately 8 mm of clearance
between the bobbin winder wheel
(2) and the belt (3).
8. Belt cover
1. Remove the two screws (2) and two
washers (3) from the side of the
sewing machine.
Install the belt cover (1) to the
sewing machine with
screws (2) and two washers (3).
the two