Remote Controller; Changing The Battery - Telefunken TF-LED32S11 Instruction Manual

Remote controller (RC)
EXIT
STOP
1. STANDBY(POWER): Standby turn on and
off.
2. SOURCE: Select the signal source.
3. 0~9: Continue to press the keys to select
a channel.
4. DISPLAY: Display the information of
current video and audio.
5. RECALL: Return to previous channel.
6. FREEZE: Freeze the picture.
7. FAV+: Add favorite.
8. CH LIST: Channel list
9. FAV.LIST: Favorite channel list
10. VOL+: Increase the volume.
11. CH+: Select the channel forward.
12. MUTE: Mute sound.
13. VOL-: Decrease the volume.
14. CH-: Select the channel backward.
15. MENU: Enter or exit menu.
16. EXIT: Exit menu or operation.
17. UP/DOWN/LEFT/RIGHT key: The menu
item selection.
18. ENTER: Confirm or enter.
19. S.MODE: Select the sound mode.
20. TEXT/ : Press one time to pause,press
again
to playback.
21. INDEX/ : Stop the playback and return to
filelist
22. P.MODE: Select the picture mode.
23. ZOOM: Zoom in or out the current
picture.(Some pictrues or videos may not
be operated.)
24. A-B: Setup repeat play segment.
25. REPEAT: Allows you to repeat single,
random, shuffle and folder.
26. REVEAL/FB: Fast Backward
27. SUBPAGE/NEXT: Next
28. HOLD/FF: Fast Forward
29. MIX/PREV.: Previous
30. RED: Access the red item or page.
31. BLUE: A-ccess the blue item or page.
32. GREEN: Access the green item or page.
33. YELLOW: Access the yellow item or
page.

Changing the battery

1. Remove the battery compartment cover
on the back of the RC.
2. Insert two AAA batteries into the battery
compartment making sure that the correct
polarity is observed.
3. Install the cover back.
• The RC should be pointed at remote
sensor within 8 meters and within 30 degrees
at the left or the right side.
Operation
7
7