Repairs; What To Do If; Tips For Saving Energy - Gastro-Cool GCFC100 Instructions For Use Manual

11 Repairs

WARNING:
Repairs to electrical appliances may only be
!
carried out by an expert qualified to do so. A repair carried
out incorrectly or unprofessionally puts the user at risk and
leads to the warranty becoming invalid!
WARNING:
Do not damage the refrigerant circuit.
WARNING:
Do not use electrical appliances inside the
food storage compartments of the appliance, unless they
are of the type recommended by the manufacturer.

12 What to do if...

Solutions to problems
The design of the appliance warranty interruption-free operation and a long
working life. If nevertheless a fault does occur during operation, check whether
this can be traced back to an operating error.
Any subsequent faults can be eliminated by yourself by checking the possible
causes:
34
Fault Possible Causes
The appliance is Is the mains plug in the
not cooling socket?
Has the fuse in the socket
been triggered?
The appliance Is the appliance standing
is noisy when vertically or horizontally?
operating
Water is lying on Has the temperature
the bottom of regulator been set
the refrigerator correctly?
Is the condensation water
channel blocked?
The appliance Is the appliance ventilation
is not cooling blocked?
correctly

13 Tips for saving energy

Do not place the appliance close to stoves, heating elements or other heat
sources. With a high ambient temperature the compressor runs more frequently
and for longer. This leads to unavoidable high power consumption.
Make sure that there is sufficient aeration and ventilation at the appliance base
and to the back of the appliance. Ventilation openings must never be covered.
The door should only remain open for as long as required.
The door seals of your appliance must be fully intact so that the doors close
correctly.
Do not set the temperature any lower than required.
Measures
Insert the mains plug
correctly in the mains
socket, switch on the fuse,
if required call for expert
assistance.
Adjust the appliance using
the feet.
The flow noises in the
refrigerant circuit are
normal.
Correct the temperature
regulator setting. Clean the
outflow opening with a pipe
cleaner.
Clear the ventilation slot,
position the appliance
freely.
35