Electrolux EHD6740FOK User Manual page 16

16 www.electrolux.com
Problem
and a number come on. There is an error in the
comes on.
comes on.
comes on.
comes on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
Possible cause
The diameter of the bottom
of the cookware is too
small for the zone.
The cookware does not
cover the cross / square.
hob.
The electrical connection is
incorrect. The supply volt‐
age is out of range.
There is an error in the hob
because a cookware
boiled dry. Automatic
Switch Off and the over‐
heating protection for the
zones operate.
The cooling fan is blocked. Check if objects block the
The electrical connection is
incorrect. The hob is con‐
nected only to one phase.
three digit letter code for the glass
ceramic (it is in the corner of the glass
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
Remedy
Use cookware with correct
dimensions.
Refer to "Technical infor‐
mation" chapter.
Cover the cross / square
fully.
Disconnect the hob from
the electrical supply for
some time. Disconnect the
fuse from the electrical
system of the house. Con‐
nect it again. If comes
on again, speak to an Au‐
thorised Service Centre.
Speak to a qualified electri‐
cian to check the installa‐
tion.
Deactivate the hob. Re‐
move the hot cookware.
After approximately 30
seconds, activate the zone
again. If the cookware was
the problem, the error mes‐
sage goes out. Residual
heat indicator can stay on.
Let the cookware become
sufficiently cool. Check if
your cookware is compati‐
ble with the hob.
Refer to "Hints and tips"
chapter.
cooling fan. If comes
on again, speak to an Au‐
thorised Service Centre.
Speak to a qualified electri‐
cian to check the installa‐
tion. Refer to the connec‐
tion diagram.