Advertisement
TROUBLESHOOTING
TROUBLESHOOTING
TROUBLESHOOTING
When this happens
這個時候
Water is
deposited
in the ice case.
Ice sheet is
formed
製冰盒內積水
後會造成連
接冰
50
R-X6000J (C)_A4.indd 50
R-X6000J (C)_A4.indd 50
故障了嗎﹖
故障了嗎﹖
故障了嗎﹖
故障了嗎﹖
Please check
檢查項目
Is the ice maker used without attaching
the ice tray?
是否是在沒有裝置製冰盒的情況下使用？
Was the ice tray filled with water when it
was set in the automatic ice maker?
是否是在製冰盒內有水的情況下裝置在
自動製冰部位了？
Is there scratch or damage on the ice tray?
製冰盒是否有傷痕？
After pulling out the frame, was it set back
with water or ice left in the ice tray?
是否是將框取出後，在留有殘水，殘冰的
情況下再次設定了？
Is the frame pushed in until the end?
框是否設定到位了？
Is the ice tray removed without pressing
the "Large ice cube making" button?
是否是在沒有按下「 製冰選擇 」鍵就取出
製冰盤？
Did a power failure occur while the ice
tray is removed?
在取出製冰盤的時候，是否停電了？
Cause
原因
Make sure to attach the ice tray when using
the ice maker.
Pg. 29, 42
一定要在裝置好製冰盒的前提下使用。
(
)
29, 42頁
Make sure to empty the ice tray before setting
it in the ice maker.
Pg. 29, 42
製冰盒一定要在空空的前提下使用。
(
)
29, 42頁
Use of cleanser or scrub brush could result in
scratch or damage on the ice tray and ice
removing may thereby become difficult.
在打理的時候，如使用刷和清洗粉就會使
製冰盒受傷，冰塊掉落時不順利。
Do not pull out the frame for any purpose other
than cleaning and replacing the ice tray. Make
sure that the ice tray is empty when setting
back the ice tray after pulling out the frame.
Pg. 29, 42
除了裝置或清洗以外，不要取出框。取出後
一定要在盒內是空矌的情況下裝置。
(
)
29, 42頁
When setting back the frame after pulling it
out, push it in until the end and pull up the
frame lever.
Pg. 29, 42
取出框後再次設定的時候，一定設定到位
將手把拉起。
(
29, 42頁
Make sure to press the "stop ice making" button
before removing the ice tray.
取出製冰盒時，一定按下「停止製冰」鍵。
(
)
42頁
Automatic
ice
making
automatically after recovered from power failure.
Press the "stop ice making" button again.
Pg. 31
停電後再次運作時會自動製冰。一定要再
次按下「停止製冰」鍵。
(
)
Pg. 42
is
performed
)
31頁
2/5/08 3:25:25 PM
2/5/08 3:25:25 PM
Advertisement
