Advertisement
When this happens
這個時候
The frame
cannot be
pulled out
框不能拉出來
Size of ice
cannot be
changed
冰塊的大小
不變
Ice cube are
round, small,
joined
together
冰塊變圓．
變小．黏著
在一起
Projection
突起
Ice cube are
round, small,
joined
together
冰塊變圓．
變小．黏著
在一起
R-X6000J (C)_A4.indd 49
R-X6000J (C)_A4.indd 49
Please check
檢查項目
Is the lever pulled down?
手把拉下來了吧？
Was the "Large ice cube making"
button pressed?
按下了 「製冰選擇」 鍵了嗎？
Size of ice may not change immediately after the setting of the large ice cube making
is changed.
製冰設定剛結束時，冰塊的大小是不會馬上變的。
"Larger" size of ice may not be
made if the water level in the water
supply container is low.
給水槽內的水量變少的話，就不
能製出大塊的冰。
Is horizontal adjustment made
properly?
是否沒有調整好平行調整。
Has the ice been left stored for a long time?
冰塊是否放太久了？
Has the door been opened frequently
or left open for a long time?
有無頻繁開啟箱門．打開箱門的時間
過久？
Is there a blackout?
有無停電？
Was the ice tray set with water in it?
是否在製冰盒內有水的情況下裝置的？
When the water in the water supply container runs out and has just been filled, the first ice
to come out of the machine may be joined together or small.
If ices cubes are joined, separate them with the provided ice scoop.
有時候當給水槽內沒水了，或者注水後剛開始做好的冰塊也會發生相互連結或變小。
冰塊粘連時，請用附屬的冰鏟加以分開。
Water passage is made on the ice tray to make ice cubes of uniform size.
This water passage makes projection at the end of ice cube.
要做出一樣大小的冰塊時後，製冰盒有這樣的水路設計，這樣的水路設計會使做出
來的冰塊前端會產生突起狀。
（Continue）
Cause
原因
Pull down the lever before pulling out the frame.
Pg. 42
按下手把後將框拉出來。
(
It cannot be pulled out during automatic ice
making operation. To pull it out, stop ice
making and if the light is flashing, wait for
approximately 20 seconds until the light turns
off.
Pg. 31
在自動製冰時不能拉出來。要將框拉出來，
可以先按下 「停止製冰」 按鍵，顯示燈會閃爍
約 20 秒鐘，待顯示燈熄滅後才能拉出。
(
)
31頁
Add water in the water supply container.
Pg. 28
往給水槽內注水。
(
28頁
Is horizontal adjustment is not made properly,
ice size cannot be uniform.
沒有調整好平行整的調話，就製不出平均
(
)
大小的冰塊。
12頁
This is because ice was sublimated.
冰塊融化了。
Ice cannot be made until the freezer
compartment is sufficiently cooled.
冷凍室不夠冷的時候就不能結冰。
Ice cannot be made until the freezer
compartment is sufficiently cooled.
冷凍室不夠冷的時候就不能結冰。
Make sure to empty the ice tray before setting
it in the ice maker.
一定要在製冰盒內是空的情況下裝置。
（繼續）
)
42頁
)
Pg. 12
49
2/5/08 3:25:25 PM
2/5/08 3:25:25 PM
Advertisement
