Register Online; Troubleshooting - Black & Decker BESTA510 Instruction Manual

Fig. Q
22
• Insert the 3/4 inch (19mm) end of the bulk line into
the hole in the spool adjacent to the slot as shown
23
in Fig. R. Make sure the line is pulled tight against the
spool as shown in Fig. S.
Fig. R
24
• Wind the cutting line onto the spool in the direction of
the arrow on the spool. Make sure to wind the line on
neatly and in layers. Do not crisscross (Fig. S).
• When the wound cutting line reaches the recesses
cut the line. (Fig. R).
• Fit the spool onto the trimmer as described in
"REPLACING THE SPOOL".

CAUTION: Before you begin trimming, only use the
appropriate type of cutting line.
Fig. S

Troubleshooting

Trimmer Runs Slowly
1. Unplug the trimmer.
2. Check that the spool housing can rotate freely. Carefully
clean it if necessary.
3. Check that the cutting line does not protrude more
than approximately 5-3/8 inches (136mm) from the
spool. If it does, cut it off so that it just reaches the line
trimming blade.
Automatic Line Feed Does Not Work
21
1. Unplug the trimmer.
2. Remove the spool cap.
3. Pull the cutting line until it protrudes approximately
5-3/8 inches (136mm) from the spool. If insufficient
cutting line is left on the spool, install a new spool of
cutting line.
4. Ensure that the line is not crisscrossed on the spool as
detailed in Fig. S. If it is, unwind the cutting line, then
wind it back on the spool neatly so that the lines do
not cross.
5. Ensure the beginning of the cutting line is pulled tight
against the spool as shown in Fig. S.
23 6. Align the tabs on the spool cap with the cut outs in
the housing.
7. Push the spool cap onto the housing until it snaps
securely into place.
8. If the cutting line protrudes beyond the trimming
blade, cut it off so that it just reaches the blade. If the
automatic line feed still does not work or the spool is
jammed, try the following suggestions:
9. Carefully clean the spool and housing.
10. Remove the spool and check if the lever in the spool
housing can move freely.
11. Remove the spool and unwind the cutting line,
24 ,
then wind it on neatly again. Replace the spool into
the housing.
Repairs


Register Online

Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
• FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at www.blackanddecker.com
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a BLACK+DECKER
factory service center or a BLACK+DECKER authorized
service center. Always use identical replacement parts.
English
9