Fitting And Removal Of Base - Iiyama ProLite E2008HDSV-1 User Manual

FITTING AND REMOVAL OF BASE

The monitor is supplied complete with a stand. If you prefer to wall mount the monitor, please follow
the instructions below to remove the stand. Be sure to include the stand with the monitor if it is
necessary to return the unit.
Put the monitor on a stable surface. The monitor may cause injury or damage if it
CAUTION
falls or is dropped.
Do not give a strong impact to the monitor. It may cause damage.
Unplug the monitor before removal or installation to avoid electric shock or damage.
<Installation>
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay
the monitor fl at on a table with front face down.
The Stand-Bottom is pulled up as shown in the fi gure.
Install the Stand-Base to the Stand-Bottom.
<Remove>
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay
the monitor fl at on a table with front face down.
Hold down the hooks outside and pull the Stand-Base away from the Stand-Bottom.
BEFORE YOU OPERATE THE MONITOR 5