Table of Contents
Advertisement
CAUTION:
Before installing the battery cartridge into the tool,
•
always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
Do not pull the switch trigger hard without pressing
•
the lock-off lever. This can cause switch breakage.
1
015631
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool,
press the lock-off lever and pull the switch trigger.
Release the switch trigger to stop.
Indicating remaining battery capacity
(Country specific)
015642
When you turn the tool on, the battery indicator shows
the remaining battery capacity.
The remaining battery capacity is shown as the
following table.
Battery indicator status
Blinking
On
Off
015624
1. Switch trigger
2
2. Lock-off lever
1. Battery indicator
1
Remaining battery capacity
50% - 100%
20% - 50%
0% - 20%
Charge the battery
Automatic speed change function
015638
Mode indicator status
015137
This tool has "high speed mode" and "high torque
mode". It automatically changes operation mode
depending on the work load. When mode indicator lights
up during operation, the tool is in high torque mode.
Tool / battery protection system
The tool is equipped with a tool/battery protection
system. This system automatically cuts off power to the
motor to extend tool and battery life.
The tool will automatically stop during operation if the
tool or battery are placed under one of the following
conditions. In some conditions, the indicator lights up.
Overload protection
When the tool is operated in a manner that causes it to
draw an abnormally high current, the tool automatically
stops without any indications. In this situation, turn the
tool off and stop the application that caused the tool to
become overloaded. Then turn the tool on to restart.
Overheat protection for tool
When
the
tool
automatically and the battery indicator shows following
state. In this situation, let the tool cool before turning the
tool on again.
Battery indicator
015625
8
1. Mode indicator
1
Operation mode
High speed mode
High torque mode
is
overheated,
the
On
Off
Tool is overheated
tool
stops
Blinking
Advertisement
Table of Contents
