Table of Contents
Advertisement
Heat sink and fan assembly
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
The heat sink might be very hot. Before you open the computer cover, turn off the computer and wait several
minutes until the computer is cool.
For access, do the following:
1. Remove the computer cover. See "Computer cover" on page 56.
2. Remove the front bezel. See "Front bezel" on page 57.
3. Remove the drive bay assembly. See "Drive bay assembly" on page 58.
4. Disconnect the microprocessor fan cable from the system board.
.
Chapter 6
Hardware removal and installation
77
Advertisement
Table of Contents
