Door Reversal - Russell Hobbs RH60FF186 Instruction Manual

Door Reversal

To reverse the door you will need to tilt the appliance backward to access the
lower hinge which holds screws. Do not tilt the appliance more than 45 degrees
and do not lay the appliance flat on its side.
For your own safety, a minimum of 2 people should lift or tilt this product.
Tools Required: Cross headed screwdriver, flat headed screwdriver and hexagonal
spanner.
1. Remove the screws from the hole cover on the left side of the appliance, take it
off and pull out the communication connector from the hole on the cabinet that
has been exposed by the removal of the hole cover.
Hole cover
Hole on the cabinet
(communication
connector is located in
here)
2. Remove the end cap cover and pull out the door bush and communication line
(the door bush is at the base of the communication line). Fit the door bush into
the door bush hole and reinstall the door end cap cover (leaving the
communication line exposed).
End cap cover
Door bush &
Communication line
Door bush hole
For Customer Services & Spare Parts please call 0345 208 8750
Opening times: Monday - Friday 8am – 8pm & Saturday 9am – 1pm
or visit us at www.productcare.co.uk
16