www.aeroplusrc.com
Fit the aileron servo and drill fine holes where the servo screws will fit. Then apply
thin cyano to strengthen the holes.
If required install a servo extension lead onto the servo, remember to use a servo
plug clip.
Fit the servo and centre the servo arm.
Using the pushrod supplied screw ball joints onto each end. The correct length will
leave the aileron lined up to the inner part still attached to the wing.
www.modellmarkt24.ch
www.modellmarkt24.ch
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com