Insulation Blankets - Rheem RTGH-C95XLP Use And Care Manual

Insulation Blankets

In general, insulation blankets for external use on gas
water heaters are not necessary. The purpose of an
insulation blanket is to reduce the standby heat loss
from the water heater's storage tank. Since these water
heaters do not store water, they eliminate the need for
the insulation blanket.
WARNING:
!
Never cover the air inlet, flue
outlet, or operating and warning labels attached to the water
heater. Covering these components will cause dangerous
operating conditions that can lead to death, personal injury,
property damage, and/or product damage.
Installation Precautions
Follow all installation instructions covered in this
manual.
Check the inlet gas pressure to make sure it is within
the range specified on the rating plate.
Make sure there is adequate air for combustion and
ventilation as described on pages 37–38 or page 44 in
this manual.
Maintain proper clearances to combustibles and
noncombustibles as specified on the rating plate.
Make sure the venting system complies with local
codes, National Fuel Gas Code (ANSI Z223.1/NFPA
54) or Natural Gas and Propane Installation Code
(CAN/CSA B149.1), and the guidelines found on pages
34 through 46 in this manual.
Make sure the heater and remote control are properly
fastened to their mounting surfaces.
Make sure the heater and remote control are wired in
accordance with all regulations and codes without any
exposed connections.
INSTALLATION INSTRUCTIONS
The manufacturer's warranty does not cover any
damage or defect caused by insulation, insulation
attachment, or use of any type of energy-saving or
other unapproved devices (unless authorized by the
manufacturer). The use of unauthorized energy-saving
devices can result in death, personal injury, and/or
property damage. The manufacturer disclaims any
responsibility for such loss or injury resulting from the
use of such unauthorized devices.
Contact the local gas company to make sure the gas
meter and gas piping are adequately sized.
Use only Teflon tape on all male water line connections
and fittings.
DO NOT block or restrict any outside air intake
openings.
DO NOT remove the front cover unless absolutely
necessary. This should only be done by a qualified
service technician.
DO NOT install this product where standing water may
occur.
DO NOT use pipe dope on water line connections and
fittings.
DO NOT use Teflon tape on gas line connections and
fittings in US.
65