Rheem RTGH-C95XLP Use And Care Manual page 64

INSTALLATION INSTRUCTIONS
Electrical Wiring (cont.)
Connecting the Remote Control to the Water Heater:
1
Ensure that the power to the water heater has been
disconnected.
Remote Control Remote Control
Connection Cover Connection Cover
2
Loosen the one screw located on the remote control
connection cover. The connection cover is made of
white plastic.
NOTICE:
DO NOT REMOVE FRONT PANEL. Remote control wires are
connected on the bottom of the unit.
There are NO accessible remote control terminals
inside the water heater.
3
Connect the remote control extension cables from
the remote control to the remote control connection
terminals.
NOTICE:
The remote control wire connection terminals are not
polarity-sensitive.
64
4
Firmly tighten the terminal screws by hand.
5
Secure the remote control extension cable on the hook
located on the side of the remote control connection
base.
6
Reinstall the remote control connection cover and
secure with the one screw.
NOTICE:
DO NOT connect power until venting installation is
complete.
7
Switch on the power supply to the water heater.
Check for proper operation of the remote control and
the water heater.