Table of Contents
Advertisement
English
Use Mode: When the FLEXVOLT
in a D
WALT 18V (20V Max) product, it will operate as an 18V
e
(20V Max) battery. When the FLEXVOLT
(60V Max) or a 108V (120V Max) (two 54V (60V Max) batteries)
product, it will operate as a 54V (60V Max) battery.
Transport Mode: When the cap is
attached to the FLEXVOLT
TM
battery is in Transport mode. Keep the
cap for shipping.
When in Transport mode, strings of cells are electrically
disconnected within the pack resulting in 3 batteries with a
lower Watt hour (Wh) rating as compared to 1 battery with a
higher Watt hour rating. This increased quantity of 3 batteries
with the lower Watt hour rating can exempt the pack from
certain shipping regulations that are imposed upon the higher
Watt hour batteries.
For example, the Transport Wh rating might indicate 3 x 36 Wh,
meaning 3 batteries of 36 Wh each. The Use Wh rating might
indicate 108 Wh (1 battery implied).
Example of Use and Transport Label Marking
Storage Recommendations
1. The best storage place is one that is cool and dry away
from direct sunlight and excess heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not in use.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool, dry place out of the charger for
optimal results.
nOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be recharged
before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the labels
on the charger and the battery pack may show the following
pictographs:
Read instruction manual before use.
See Technical Data for charging time.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
10
TM
battery stands alone or is
battery is in a 54V
TM
battery, the
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for
the environment.
Charge D
WALT battery packs only with designated
e
D
WALT chargers. Charging battery packs other
e
than the designated D
D
WALT charger may make them burst or lead to
e
other dangerous situations.
Do not incinerate the battery pack.
USE (without transport cap). Example: Wh rating
indicates 108 Wh (1 battery with 108 Wh).
TRANSPORT (with built-in transport cap). Example:
Wh rating indicates 3 x 36 Wh (3 batteries of 36 Wh).
Battery Type
The DCG405 operates on a 18V(20V MAX) battery pack.
These battery packs may be used: DCB181, DCB182, DCB183,
DCB184, DCB185, DCB187, DCB189, DCB203, DCB204, DCB205,
DCB546, DCB547, DCB548, DCB606, DCB609, DCB612. Refer to
Technical Data for more information.
Package Contents
The package contains:
1 Angle grinder
1 Guard
1 Side handle
1 Backing flange
1 Locking flange
1 Hex wrench (A9 only)
1 wrench(TW, KR only)
1 Li-Ion battery pack (C1, D1, L1, M1, P1, S1, T1, X1 models)
2 Li-Ion battery packs (C2, D2, L2, M2, P2, S2, T2, X2 models)
3 Li-Ion battery packs (C3, D3, L3, M3, P3, S3, T3, X3 models)
1 Instruction manual
•
Check for damage to the tool, parts or accessories which may
have occurred during transport.
•
Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
WALT batteries with a
e
Advertisement
Table of Contents
