Grundig BDFN Series User Manual page 34

Hygiene Intense function
(depends on the model)
Designed to be used when more hygiene
is required for washing the dishes. This
function increases the washing and rinsing
temperatures in the selected cycle and
extends the periods of these steps in the
cycle. Moreover, an additional rinsing cycle
is performed to wash and rinse your dishes
with more hygiene.
TrayWash Function
(depends on the model)
Select Intensive 70°C programme and
press function key to run this function.
Floor illumination
Warning to show that machine is in
washing phase
(depends on the model)
Your machine reflects a light to the floor
during the washing process. This light turns
off after the washing process is complete.
Floor illumination is activated
automatically when the washing
programme starts and remains lit until
the end of the programme.
Floor illumination cannot be cancelled
by the user.
Interior Illumination
(Depends on the Model)
In suitable models there is a lamp
illuminating the inside of your machine
when the door is opened.
1. Press the On/Off key and P2 program
key simultaneously for 3 seconds and
enter the Settings menu after turning
your machine on with On/Off key,
depending on the model you may enter
the Settings Menu by pressing the P3
key for 3 seconds.
2. Move to "L:" position on the screen
by pressing the P2 key . Select the
desired position with P3 program
key. Interior illumination feature is off
in "L:0" position and active in "L:1"
position.
34/EN
3. To save, exit the settings menu by
pressing on/off key of your machine
for 3 seconds. Your settings shall be
saved automatically.
SelfDry
(Depends on the Model)
Thanks to the "SelfDry" feature on your
machine, the drying effectiveness of your
machine is improved and power is saved.
There are two options, namely "OFF" and
"ON".
You may use sub-menu settings to change
"SelfDry" settings.
When you activate this function, the door
of your machine is opened automatically at
the end of the washing cycle.
SelfDry feature opens the door at
the end of the washing cycle thanks
to the "door opening shafts". This
process takes about 2 minutes. Do not
force to close the door if the power is
interrupted while the shafts are moving
out. Operation shall be completed
and shafts shall be retracted when the
power is restored.
SelfDry function may cause changes to
the cycle time.
To enable SelfDry Function:
1. When the door is closed, to enable
SelfDry function, press and
hold the F3 and F4 function keys
simultaneously.
2. SelfDry indicator turns on and Auto
Door Opening function is enabled.
SelfDry function could be enabled or
deactivated in Program Selection mode.
To cancel SelfDry Function :
1. When the door is closed, to disable
SelfDry function, press and
hold the F3 and F4 function keys
simultaneously.
2. SelfDry indicator turns off and the
function is disabled.