Monacor JTS CS-W4C/6 Instruction Manual page 31

Menu item
4.Mic. RF Power
5.Mic. Auto OFF
6.Mic. KeyLock
7.Remoset Config
8.Return
Fig. 30 Setting options for the transmitters
1) Turn the knob PUSH /CONTROL to select the
setting function Then press the knob to call
up the function
2) Turn the knob PUSH /CONTROL to make
the setting Then press the knob to save the
setting
3) Use the menu item
select the settings that are to be transferred
to the transmitter by means of the REMOSET
function To select or deselect the function,
press the knob PUSH /CONTROL
transfer of the setting
no transfer of the setting
To save the selection made, go to the line
Save and Exit
To exit the submenu without saving the
changes made, go to the line
out Save
4) To transfer the settings, press the button EXIT
to exit the menu and then start the REMOSET
transmission (chapter 4 5 5)
4.7 Priority settings
To increase speech intelligibility, the automatic
mixing function only unmutes a single micro-
phone channel at a time and suppresses the sig-
nals of the other channels Via a priority option
for any channels, the chairperson, for example,
will be able to take the floor at any time
1) Via the menu item
highest menu level (fig 7 in chapter 4 3), call
up the following menu:
Setting
transmission power
10 / 50 mW
without any function for
CS-W4T
without any function for
CS-W4T
to select settings for
transfer
to go back to the
higher-level menu
Remoset Config
or press the button SETUP
Exit With-
in the
3. Priority
Bypass
Threshold
Rx1 Priority Yes
Rx2 Priority No
Rx3 Priority No
Rx4 Priority No
Delay Time
Return
2) To select the line to be set, turn the knob
PUSH / CONTROL
3) To change the setting, press the knob
PUSH / CONTROL; to change a value in the
line to be set, press the knob and then turn
the knob, finally press the knob again
4) Press the knob SETUP to save the settings
made or exit the submenu by means of the
button EXIT or via the line
When the option
the automatic mixing function will be deactivated
and it will not be possible to make any further
to
setting in this menu In this case,
all receiver sections
can be simultaneously used for speaking The LED
indicators AF (11) of all receiver sections will light
up permanently in this operating mode as soon as
a radio signal of the transmitter is being received
When the automatic mixing function is activated
( ), the following setting options will
Bypass No
be available:
Threshold
Threshold value for the audio signal level of the
microphone (minimum volume while speaking) to
switch on a microphone channel [the LED indi-
cator AF (11) of the receiver section will light up]
Delay Time
Time the microphone channel will remain acti-
vated after speaking or in speech pauses
Priority No
When a channel without priority (
) is used for speaking, the signals of the other
No
channels without priority will automatically be
suppressed (i e attenuated by approx 30 dB)
These channels will only available for speaking
when the previous speaker has finished speak-
ing or makes a speech pause of sufficient length
(
Delay Time
No
-50 dB
3 Sec
Fig. 31
Return
is selected for
Yes
Open
that all microphones
Rx1...4
/
Yes
Priority
)
,
Bypass
means for
31