Monacor JTS CS-W4C/6 Instruction Manual page 27

4.5.1 Setting the frequency manually
1) The setting menu for the receiver section can
be called up in two ways:
1 Press the button SET (12) of the receiver sec-
tion desired (on the display, the field of the
receiver section is highlighted); then keep
the button SETUP (6) pressed until the menu
(fig 13) is shown
2 Keep the button SETUP pressed until the menu
with the line
1.System Options
Use the button PUSH / CONTROL (7) to select
the receiver section CH1– CH4 and then press
the button to call up the setting menu
FREQ. G-CH ID
1
627.500 1-1 1
2 ?
628.500 1-2 2
3 632.000 1-3 3 -10
×
4 634.125 1-4 4 -10
×
Fig. 13 Current settings of the receiver sections:
Frequency, Group, CH = channel, ID number for the
REMOSET function, = volume [adjustable with
(13)], = battery status of the transmitter,
status not transferred yet,
2) Call up the frequency setting via the menu
item
1.Frequency
Setup Frequency
627.500 MHz
G:1 CH:1
3) Turn the knob PUSH /CONTROL to set the
frequency in steps of 1 MHz
4) For fine adjustment in steps of 0 025 MHz,
press the knob so that the digits after the deci-
mal point are highlighted Then turn the knob
If the frequency is identical to the frequency
of a channel in a group, the group number
and the channel number are shown in the
lower line
5) Press the button SETUP to save the frequency
adjusted
4.5.2 Selecting a frequency from a group
The easiest way to operate multiple transmitters
at the same time is to select the frequencies from
one of the 6 groups:
1) Call up setting menu for the receiver sec-
tion (chapter 4 5 1); then call up the group
and channel selections via the menu item
2.Group/Channel
is shown
1.Frequency
0
2.Group/Channel
-2
3.Scan
4.Squelch
 
= battery
?
= no reception
×
:
Fig. 14
:
Setup Group
G: 3 CH:18
656.650 MHz
2) Turn the knob PUSH /CONTROL to select the
group
3) Press the knob to highlight the channel num-
ber Then turn the knob to select the chan-
nel The corresponding reception frequency
is shown in the lower line
4) Press the button SETUP to save the setting
4.5.3 Scan function
Before a transmission channel is selected, the
scan function can be used to determine if other
transmission systems are currently transmitting
on the channels of the receiver CS-W4C The
channels already used will be skipped during
channel selection
Call up the setting menu for the receiver section
(chapter 4 5 1); then call up the selection menu
for scanning via the menu item
1.All Groups
2.Result List
3.Current Group
4.Return
It is possible to scan the channels of all groups
(table on page 34) (this will take approx 1 min-
ute) or only the channels of one group (this is
faster)
Note: To return to the setting menu, use the menu
item
4.Return
4.5.3.1 Scanning all channels
1) Select the menu item
(fig 16) if it has not been selected yet Then
press the knob PUSH / CONTROL
Scan All Groups
Press Setup or Enter to
start scan.
Press Exit to quit.
2) Press the button SETUP or the knob PUSH /
CONTROL to start scanning The display shows
Scanning...
the button EXIT
Fig. 15
3.Scan
Fig. 16
1.All Groups
Fig. 17
To exit at any time, press
%
27