Roland V-Drums PD-128-BC Owner's Manual page 9

4.
Pull the fastening clip upward and out, and
remove the covering.
Fastening Clip
5.
Attach the new covering.
Insert the lower part of the covering into the rubber
groove so that the upper edge of the covering is in the
position shown in the illustration.
Both edges of the covering will fit into the gap between
the shell and plate.
Covering
Shell
6.
While pulling on both ends of the covering so as
to eliminate any slack, finger-tighten the screw
that holds the covering in place.
7.
Using a Phillips screwdriver, securely fasten the
screw that holds the covering in place.
8.
Attach the fastening clip in the location shown in
the illustration, as if to pinch the two ends of the
covering.
Covering
The upper edge
of the covering
Plate
Screw
Fastening clip
Connecting to the Percussion Sound Module
9.
Install the frame in the shell.
The frame's output jack will be pointing in the same
direction as the bracket.
Output jack
Protrusion
Groove
10.
Attach the hoop and head, and tighten the
tuning bolts.
11.
Adjust the tension of the head.
Refer to "Adjusting the Head Tension" (p. 7).
Covering size
PD-128S/PD-128
• 77 (Width) x 927 (Length) mm
77 mm
• Maximum Thickness: 1 mm
PD-108
• 77 (Width) x 767 (Length) mm
77 mm
• Maximum Thickness: 1 mm
Frame
Shell
Bracket
Match up the protrusion on
the frame with the groove
on the shell.
927 mm
767 mm
9