RedMax EBZ8560RH Operator's Manual page 13

• Stop the product with the stop switch (4).
4
To start the product
1. If the engine is cold, push the choke lever to the
closed choke position.
2. Push the air purge bulb again and again until fuel
starts to fill the air purge bulb. It is not necessary to
fill the air purge bulb fully.
3. Push the throttle lever to the ⅓ speed position. Refer
to To operate the throttle switch : EBZ8560RH on
page 12 .
4. Put the product on a flat surface on the ground.
5. Hold the product with the left hand.
1654 - 002 - 19.04.2021
6. Pull the starter rope handle slowly until resistance
7. Pull the starter rope handle quickly with the right
1
2
3
8. Move the choke lever to the open choke position
9. Pull the starter rope handle repeatedly until the
10. If the engine does not start, do step 1 to step 10
11. Let the engine run for 2-3 minutes to become warm
To stop the product : EBZ8560RH
1. Push the throttle lever to the stop position.
To stop the product : EBZ8560
1. Push the stop switch.
occurs.
hand until the engine starts or attempts to start,
maximum 10 times. If the engine starts, move the
choke lever gradually to the open position.
Note:
Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
until the choke lever stops.
engine starts and continues to run.
again.
before operation.
CAUTION:
full speed.
CAUTION:
full speed.
Do not stop the product at
Do not stop the product at
13