Table of Contents
Advertisement
en Troubleshooting
Fault
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Detergent residue on
the damp washing.
Detergent residue on
the dry laundry.
Water is leaking out at
the water inlet hose.
Water is leaking out at
the water outlet hose.
The drying time is too
long.
Fluff on the laundry.
Water inlet noise dur-
ing the drying phase.
Drying programme
does not start.
44
Cause and troubleshooting
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the
programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the
programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Brush out the laundry after washing and drying.
▶
Water inlet hose is not correctly/securely connected.
Connect the water supply hose correctly.
1.
→ "Connecting the water inlet hose", Page 15
Tighten the screw connection.
2.
The water outlet hose is damaged.
Replace the damaged water outlet hose.
▶
Water outlet hose is not connected correctly.
Connect the water outlet hose correctly.
▶
→ "Water outlet connection types", Page 15
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is lower than
▶
30 °C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
Fluff has accumulated in the drum.
Run the
programme without any laundry or de-
▶
tergent.
Drying phase requires water.
Not a fault.
1.
Make sure that the water tap also remains open
2.
during the drying phase.
Door is not closed.
Close the door.
1.
Press
Inicio/Pausa+Carga to start the pro-
2.
gramme.
No drying programme is selected.
Select a suitable drying programme.
▶
→ "Programmes", Page 26
Advertisement
Table of Contents
