Tegam 932A Quick Start Manual

To access the TEGAM Cloud
and view saved measurement data:
1. Go to tegamcloud.com;
2. Click Login on the home page; This opens a user/password window;
3. Click Login to accept the pre-filled user name and password,
and access the default TEGAMUser account;
If a personalized user account has already been created for your
organization, enter the appropriate username and password to access
that account.
4. Click View Data to access your saved measurement data;
5. Click Select Device and choose your Data Thermometer's serial number
from the drop-down list;
6. Click Create Chart to display your saved measurement data.
CONGRATULATIONS!
YOU'RE READY to make and record accurate temperature
measurements, wherever and whenever you may need to.
We know you are eager to begin using your new thermometer, but this quick
start guide is just the beginning. Please take a moment to familiarize yourself
with the Operation Manual to learn about all the features and benefits of your
new TEGAM Data Thermometer.
10 TEGAM Way
Phone: 440-466-6100 Fax: 440-466-6110
•
www.tegam.com
Geneva, Ohio 44041
•
E-mail: sales@tegam.com
•
THERMOMETER 931A, 932A, 1031A, 1032A
Data Thermometer Quick Start Guide
1. Install batteries.
Battery
Compartment
Retaining Screws
Gasket
2. Press to turn the instrument on.
3. Connect a compatible temperature probe to the Channel 1 and/or
Channel 2 input connector located at the top of the instrument.
4. Set the desired thermocouple type and temperature units as follows:
a. Enter Setup Menu by pressing
1.5 seconds, and then release it;
b. The Active Thermocouple Type will flash on the display. Use
select the thermocouple type of the connected temperature probe
(B, E, J, K, N, R, S, or T);
c. Press (do not hold) to save selection and move to next parameter;
d. The Active Temperature Unit will flash on the display. Use
the desired temperature unit (°C, °F, or K);
e. Press (do not hold) to save selection and exit Setup Menu.
5. To begin collecting temperature data that will be stored in the thermometer's
onboard memory, press .
931-901 Rev. A
Battery Installation
Remove the two (2) battery compartment
retaining screws and the battery compartment
cover on the back of the instrument. Install
three (3) AA 1.5 V batteries (supplied with new
instrument). Be sure the battery compartment
gasket is properly installed and replace the
battery cover.
– hold key down for approximately
to
to select