Samsung NX58K7850S Series Installation Manual page 21

Anti-Tip
bracket
*apporoximately
21/32 (16.5 mm)
Screw must enter
wood or concrete
To check if the bracket is installed and engaged properly, remove storage drawer
and look underneath the range to see that the leveling leg is engaged in the
bracket. Carefully tip the range forward. The bracket should stop the range within
4 inches (10.2 cm) of tipping. If it does not, the bracket must be reinstalled.
If the range is pulled from the wall for any reason, always repeat this procedure
to verify the range is properly secured by the anti-tip bracket. Never completely
remove the leveling legs or the range will not be secured to the anti-tip device
properly.
Step 5. Plug in and place
WARNING
BEFORE OPERATING OR TESTING, follow the grounding requirements on pages
20 ~ 22 in this manual. Improper connection of the grounding plug can result in a
risk of electric shock.
All gas ranges come with a power cord. The power cord is connected to the
•
rear of the range. Please review "Electrical requirements" on pages 20 ~ 22.
• All U.S. and Canadian models are produced with a 3-wire, 120-volt, 60-Hertz
electrical system. The entire system, including the power cord, is preinstalled
and prewired
*NOTE: To install the Anti-
Tip bracket, release the
leveling leg.
A minimum clearance
of 21/32" (16.5 mm) is
required between the
range bottom and the
kitchen floor.
Step 6. Level the range
Leveling leg
1. Plug in the power cord. Make sure the
outlet meets local or national electrical
codes as referenced on pages 20 ~ 22.
2. Slide the range into place.
3. Check the gas supply line to make sure
it did not get damaged and it stayed
Gas Range Plug
connected during positioning.
4. Check to make sure the back leg of the
range has slid into the anti-tip bracket.
Carefully tip the range forward to
ensure that the anti-tip bracket engages
the back brace and prevents tip-over.
Make sure the range is positioned
1.
where you want it.
2. Using a wrench, level the range by
turning the front leveling legs in or
out as necessary. Counterclockwise
shortens the leg and lowers the range.
Clockwise lengthens the leg and raises
the range.
NOTE
• Adjusting the two front legs is usually
sufficient, but all four legs adjust if
necessary.
• Adjust the leveling legs only as far as
necessary to level the range. Extending
the leveling legs more than necessary
or removing legs can cause the range
to be unstable.
English 21