Precautions - Sony SHAKE-X30D Operating Instructions Manual

NO DISC
There is no disc in the unit.
NO MUSIC
No supported audio files exist in the
playback source.
NO VIDEO
No supported video files exist in the
playback source.
NOT IN USE
You tried to perform a specific
operation under conditions where
that operation is prohibited.
NOT SUPPORTED
An unsupported USB device is
connected, or the USB device is
connected through a USB hub.
OVER CURRENT
An over current from the
port was detected.
PROTECTED
The USB device is write-protected.
PUSH STOP
You tried to perform an operation
that can be performed only when
the playback is stopped.
READING
The system is reading information
of the disc or USB device. Some
operations are not available.
REC ERROR
The transfer did not start, stopped
partway, or otherwise could not be
performed.
TRACK FULL
You cannot transfer onto the USB
device because the number of files
has reached its maximum.

Precautions

When carrying the unit
To avoid damaging the disc
mechanism, perform the following
procedure before carrying the unit.
Use the buttons on the unit to
perform this operation.
1
Press  to turn on the system.
2
Press FUNCTION repeatedly to
select "DVD/CD".
3
Remove the disc.
Press  to open and close the disc
tray.
Wait until "NO DISC" appears on the
display.
(USB)
4
Unplug the AC power cord (mains
lead).
Notes on discs
Before playing, wipe the disc with a
• •
cleaning cloth from the center outward
to the edge.
• • Do not clean discs with solvents, such
as benzine, thinner, or commercially
available cleaners or anti-static spray
intended for vinyl LPs.
• • Do not expose discs to direct sunlight
or heat sources such as hot air ducts,
nor leave them in a car parked in direct
sunlight.
On safety
Completely disconnect the AC power
• •
cord (mains lead) from the wall outlet
(mains) if it is not going to be used
for an extended period of time. When
unplugging the unit, always grip the
plug. Never pull the cord itself.
• • Should any solid object or liquid get
into the system, unplug the system, and
have it checked by qualified personnel
before operating it again.
• • AC power cord (mains lead) must be
changed only at the qualified service
shop.
67
GB