Sony SHAKE-X30D Operating Instructions Manual page 61

•
— The internal memory is
fragmented.
"NO FILE" appears on the display.
The system has entered the
• •
software update mode, and
all buttons (except ) are
deactivated. Press  on the unit to
cancel the software update.
"OVER CURRENT" appears on the
display.
A problem has been detected
• •
with the level of electrical current
from the (USB) port. Turn off
the system and remove the USB
device from the port. Make sure
there is no problem with the USB
device. If this display pattern
persists, contact your nearest Sony
dealer.
Erroneous display.
The data stored in the USB
• •
device may have been corrupted,
perform the transfer again.
The character codes that can be
• •
displayed by this system are as
follows:
•
— Upper cases (A to Z)
•
— Numbers (0 to 9)
•
— Symbols (< > * +, [ ] \ _)
Other characters appear as "_".
The USB device is not recognized.
Turn off the system and reconnect
• •
the USB device, then turn on the
system.
Check the information on the
• •
website about compatible USB
devices (page 11).
The USB device is not working
• •
properly. Refer to the operating
instructions of the USB device on
how to deal with this problem.
Playback does not start.
Turn off the system and reconnect
• •
the USB device, then turn on the
system.
Check the information on the
• •
website about compatible USB
devices (page 11).
Playback does not start from the
first file.
Set the play mode to Normal Play
• •
(page 28).
Files cannot be played back.
Make sure you have selected
• •
the correct Media Mode before
playback.
USB devices formatted with file
• •
systems other than FAT16 or FAT32
are unsupported.*
If you use a partitioned USB
• •
device, only files on the first
partition can be played back.
* This system supports FAT16 and FAT32,
but some USB devices may not support
all of these FAT. For details, refer to the
operating instructions of each USB
device or contact the manufacturer.
Picture
There is no picture.
Check that the system is
• •
connected securely.
If the video cable or HDMI cable
• •
is damaged, replace it with a new
one.
Make sure you connect the unit to
• •
the HDMI input jack or the video
input jack of your TV (page 21).
Make sure you turn on the TV and
• •
operate the TV correctly.
Make sure you select the input
• •
according to the connection on
the TV so that you can view the
pictures from the system.
61
GB