Installing Additional Ram; To Install A Ram Expansion Module - HP OmniBook XE4100 Startup Manual

Installing Additional RAM

CAUTION
Add-On Devices
Installing Additional RAM
The computer has no memory (RAM) built in but has two slots that hold two RAM
modules. At least one slot contains a RAM module installed at the factory. You can use
both slots to expand your RAM.

To install a RAM expansion module

If your model has technology code KB (shown on the serial number label), use
HP PC2100 DDR-266 or higher RAM only. If your model has technology code KC, use
HP PC-133 or higher SDRAM only.
You'll need a small Phillips screwdriver for these steps.
Your computer's chips are extremely sensitive to static electricity, and can be
permanently damaged by it. Handle the RAM module only by its edges. Before
installing the memory module, discharge your body's static electricity by touching
the metal shielding around the connectors on the back of the computer.
1. Click Start, Turn Off Computer, Turn Off (Windows XP) or Start, Shut Down, Shut
down (Windows 2000).
2. Important: unplug the AC adapter, if present, and remove the battery.
3. Turn the unit bottom-side up, loosen the screws holding the RAM cover, and remove
the cover.
4. Insert the RAM board into the connector at about a 30° angle until it is fully inserted.
Then press down at both sides until both latches snap closed.
38 Startup Guide