Advertisement
Quick Links
Description
Channels
Acceleration Range
Acceleration Resolution
Calibrated Accuracy
Sample Rate
Reading Rate
Memory
Required Interface Package
Baud Rate
Typical Battery Life
Operating Environment
-20 °C to +54 °C, 0 to 95%RH (non-condensing)
Material
Dimensions
5.5 in x 5.2 in x 3.2 in (140 mm x 132 mm x 80 mm)
Weight
Approvals
*Shock101-EB Acceleration Range, Resolution and Accuracy
Range (g)
+5
Accuracy (g)
+0.2
Resolution (g)
0.01
Battery Warning
WARNING: FIRE, EXPLOSION, AND SEVERE BURN HAZARD. DO NOT SHORT CIRCUIT, CHARGE,
FORCE OVER DISCHARGE, DISASSEMBLE, CRUSH, PENETRATE OR INCINERATE. BATTERY MAY
LEAK OR EXPLODE IF HEATED ABOVE 54 °C (129 °F).
1.800.561.8187
Shock101-EB
Shock (3 axes)
*See Table Below
512 Hz
64 Hz up to 5 minutes
349,525/axis
IFC200
115,200
60 days
Anodized aluminum
5 lb (2.3 kg)
CE
+50
+100
+250
+1
+2
+4
0.05
0.1
0.2
DOC-1064035-00 REV 11 2014.07.07
www.
Product User Guide
Shock101-EB-5
Tri-axial +5G, Shock Data Logger with Extended Battery Life
Shock101-EB-50
Tri-axial +50G, Shock Data Logger with Extended Battery Life
Shock101-EB-100
Tri-axial +100G, Shock Data Logger with Extended Battery Life
Shock101-EB-250
Tri-axial +250G, Shock Data Logger with Extended Battery Life
information@itm.com
.com
Shock101-EB
Advertisement
Related Manuals for MadgeTech Shock101-5-EB
Summary of Contents for MadgeTech Shock101-5-EB
- Page 1 Product User Guide Description Shock101-EB Shock101-EB Channels Shock (3 axes) Acceleration Range Acceleration Resolution *See Table Below Calibrated Accuracy Sample Rate 512 Hz Reading Rate 64 Hz up to 5 minutes Memory 349,525/axis Required Interface Package IFC200 Baud Rate 115,200 Typical Battery Life 60 days Operating Environment...
- Page 2 Shock101-EB Product User Guide Product Notes - The status of the device will change to “Running”, “Waiting to Start” or “Waiting to Reading Intervals Manual Start”, depending upon your start method. The Shock101-EB samples at 512 Hz and at the user specified reading rate, the device - Disconnect the data logger from the interface cable and place it in the environment to writes the peak values (g-force) to memory.