Table of Contents
Advertisement
SpeciFicAtionS
Electrical Requirements 110 V~ / 60 Hz / 0.01 A
Light Strength
unpAcking
When unpacking, make sure that
the item is intact and undamaged. If any
parts are missing or broken, please call
Harbor Freight Tools at the number shown
on the cover of this manual as soon as
possible.
initiAL Set up
inStructionS
read the entire importAnt
SAFetY inFormAtion
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
From AccidentAL
operAtion:
turn the unplug the light from
the electrical outlet before
assembly.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
1.
Slide the Base (2) into the bottom of
the Lamp Assembly (1).
2.
Secure with the Knob (3).
operAting inStructionS
read the entire importAnt
SAFetY inFormAtion
SKU 66274
1430 Lux @ 12"
to preVent
SeriouS injurY
For technical questions, please call 1-800-444-3353.
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
general operating instructions
1.
Position the LED work light near the
work. Loosen Knob (3) and adjust
Lamp Assembly (1) to direct the light
beam. Tighten the Knob (3).
2.
Plug the Light into a grounded, GFCI
equipped 110V electrical outlet.
3.
To prevent accidents, disconnect
power supply after use. Clean, then
store indoors out of children's reach.
Page 6
Advertisement
Table of Contents
