Installation Options - U.S. Stove Ashley AP5770 Owner's Manual

INSTALLATION OPTIONS

 Read this entire manual before you install and use your pellet stove. Failure to follow instructions
may result in property damage, bodily injury, or even death!
(See specifi c installation details for clearances and other installation requirements)
A Freestanding Unit—supported by pedestal/legs and placed on a non-combustible fl oor surface in compliance with
clearance requirements for a freestanding stove installation.
An Alcove Unit—supported by pedestal/legs and placed on a non-combustible fl oor surface in compliance with clearance
requirements for an alcove installation.
An Insert Unit— is inserted directly into an existing fi re place.
Your pellet stove may be installed to code in either a conventional or mobile home (see SPECIAL MOBILE HOME
REQUIREMENTS). The installation must comply with the Manufactured Home and Safety Standard (HUD), CFR3280,
Part 24.
It is recommended that only a authorized technician install your pellet stove, preferably an NFI certifi ed specialist.
DO NOT CONNECT THIS UNIT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM.
The use of other components other than stated herein could cause bodily harm, heater damage, and void your warranty.
IMPROPER INSTALLATION: The manufacturer will not be held responsible for damage caused by the mal-
function of a stove due to improper venting or installation. Call (800) 750-2723 and/or consult a professional
installer if you have any questions.
CLEARANCES
Your pellet stove has been tested and listed for installation in residential, mobile home, and alcove applications in
accordance with the clearances given in FIGURES 1-2 and TABLE 1. For safety reasons, please adhere to the installation
clearances and restrictions. Any reduction in clearance to combustibles may only be done by means approved by a
regulatory authority.
FIGURE 1
SIDEWALL CLEARANCES
PARALLEL INSTALLATION
6
INSTALLATION
PARALLEL A - Backwall to unit
B - Sidewall to fl ue
C - Sidewall to top edge of unit
CORNER D - Adjacent wall to unit
TABLE 1
CLEARANCES
3.00 / 76mm
11.00 / 280mm
8.00 / 203mm
8.00 / 203mm
FIGURE 2
SIDEWALL CLEARANCES
CORNER INSTALLATION