Shutdown Procedure - U.S. Stove Ashley AP5770 Owner's Manual

KEEP HOPPER LID CLOSED AT ALL TIMES EXCEPT WHEN REFILLING.

SHUTDOWN PROCEDURE

Turning your stove off is a matter of pressing the "POWER" button on the display board. The green light will turn back to
red when the "POWER" button is pushed. The auger motor will stop, and the blowers will continue to operate until the
internal fi rebox temperatures have fallen to a preset level.
WARNING: Never shut down this unit by unplugging it from the power source.
1. Your stove is equipped with a high temperature thermodisc. This unit has a manual reset thermodisc. This safety
switch has two functions.
A. To recognize an overheat situation in the stove and shut down the fuel feed or auger system.
B. In case of a malfunctioning convection blower, the high-temperature thermodisc will automatically shut-
down the auger, preventing the stove from overheating.
NOTE: On some units, once tripped, like a circuit breaker, the reset button will have to be pushed before restarting your
stove. On other units the thermodisc has no reset button and will reset itself once the stove has cooled. The manufacturer
recommends that you call your dealer if this occurs as this may indicate a more serious problem. A service call may be
required.
2. If the combustion blower fails, an air pressure switch will automatically shut down the auger.
NOTE: Opening the stove door for more than 30 seconds during operation will cause enough pressure change to activate
the air switch, shutting the fuel feed off. The stove will shut down and show "E2" on the two digit display. The stove has
to fully shut down before restarting.
OPERATION
DO NOT OVERFILL HOPPER.
21