Table of Contents
Advertisement
26
www.aeg.com
3. Set the Pyrolysis function. Refer to
"Oven functions".
4. When
set the necessary procedure:
Option
P1
P2
Press
or turn the knob for the
temperature to start the procedure.
You can use the End function to delay
the start of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. To change the default length of the
procedure (P1 or P2), press
, and then press
the length of the cleaning procedure.
6. When the oven is at its set
temperature, the door locks. The
display shows the symbol
bars of the heat indicator until the
door unlocks.
7. When Pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
8. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
10.4 Cleaning reminder
To remind you that the Pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the appliance.
flashes, press
or
Description
If the oven is
not very dirty.
Time of the
procedure: 1
h 30 min.
If you cannot
easily remove
the dirt. Time
of the proce-
dure: 3 h.
or
to set
and the
The cleaning reminder
goes out:
to
• after the end of the
• if you press
10.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on
the two door hinges.
to set
3. Close the door until it is at an angle
of approximately 45°.
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side
down on a soft cloth on a stable
surface. This is to prevent scratches.
Pyrolysis function.
and
the same time while PYR
flashes in the display.
A
45°
at
A
Advertisement
Table of Contents
