Power Button Board - HP Envy 17-1190 Maintenance And Service Manual

Power button board

Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a. memory module compartment cover (see
b. Keyboard (see
c. Top cover (see
Remove the power button board:
1. Turn the top cover upside down, with the front toward you.
2. Remove the two Phillips PM2.5×5.0 screws (1) that secure the power button board to the
top cover.
3. Remove the power button board (2).
Reverse this procedure to install the power button board.
56 Chapter 4 Removal and replacement procedures
Battery on page 38), and then remove the following components:
Keyboard on page 51)
Top cover on page 53)
Memory module on page
Spare part number
603794-001
43)