Fanimation Old Havana FPH61RS Owner's Manual page 11

How to Assemble Your Floor / Desk Fan
1. After removing the Floor/Desk base from the carton,
place it on the floor with the flat surface resting on the
floor (Fig. 13) .
Floor /
Desk Base
2. Secure Hex Bolt and washer in Floor / Desk base with
a 5/16 Nylon Nut and Spring Washer. (Fig.14)
3. Position the Motor Assembly onto the Floor / Desk
base. (Fig.14)
4. Secure Motor Assembly and Floor / Desk base with a
bolt and washer. (Fig. 14)
5. Tighten with adjustable wrench. Do not over tighten.
Using the Floor / Desk Fan
1. Your fan is now ready to operate.
2. Plug the fan into a U.L. approved 120 volt outlet.
Fig. 13
Fig. 15
5/16 x 2½
Bolt & Washer
Motor
As sem bly
5/16 Nylon Nut
Operating the Floor / Desk
1. Check the operation of the fan by turning the speed
control to "high".
2. Your fan model is equipped with a 4-position,
3-speed control. The operating sequence is as
follows:
st
1 position - OFF
nd
2 position - HIGH
3 rd position - MEDIUM
th
4 position - LOW
Speed Control
Fig. 16
9
Hex Bolt
& Washer
Floor / Desk
Base
5/16 Spring Washer
Fig. 14
Fan