d2itsu APD-9CR User Manual page 16

INSTALLATION INSTRUCTIONS (optional)
Window
panel
Foam seal
Installation in a sliding sash window
1. Cut the foam seal(adhesive type) to the
proper length and
attach it to the window frame. See Fig.12.
Foam seal A
(adhesive type)
2. Attach the window slider kit to the window
stool. Adjust the length of the window slider kit
according to the width of window, shorten the
adjustable window kit if the width of window is
less than 26.5 inches.
Open the window sash and place the window
Fig. 12
slider kit on the window stool. See Fig.13.
3. Cut the foam seal(adhesive type) to the
proper length and attach it on the top of the
window. Shown as in Fig.14.
4. Close the sliding sash securely against the
window.
5. Cut the foam seal to an appropriate length
and sea the open gap between the top window
sash and outer window sash. Shown as in
Fig.15.
Fig. 13
NOTE: All the illustrations in this manual are
for explanation purpose only.Your unit may be
slightly different. The actual shape shall prevail.
Fig. 14
Fig. 15
11