Installing A Hard Drive; Replacing A Drive In The Upgrade Bay; Replacing A Hard Drive - HP EliteBook 2560p Getting Started Manual

Installing a hard drive

To install the hard drive:
1. Insert the hard drive into the hard drive bay at an angle (1), and then lay the hard drive flat in the
hard drive bay (2).
2. Pull the plastic tab (3) towards the center of the computer to engage the hard drive with the
connector.
3. Tighten the hard drive screws (4).
4. Replace the bottom cover (see
5. Insert the battery (see
6. Connect AC power and external devices to the computer.
7. Turn on the computer.

Replacing a drive in the upgrade bay

The upgrade bay can hold either a hard drive or an optical drive.

Replacing a hard drive

CAUTION: To prevent information loss or an unresponsive system:
Shut down the computer before removing the hard drive from the upgrade bay. Do not remove the hard
drive while the computer is on, in the Sleep state, or in Hibernation.
If you are not sure whether the computer is off or in Hibernation, turn the computer on by pressing the
power button. Then shut down the computer through the operating system.
Replacing the bottom cover on page
Inserting or removing the battery on page
38).
36).
Replacing a drive in the upgrade bay 41