Discharging The Battery Pack - HP Compaq Presario,Presario X6000 Hardware And Software Manual

Discharging the Battery Pack

Ä
CAUTION: If you plan to leave the notebook unattended during
discharge, save your work before starting the discharge procedure.
Hibernation is enabled by default but can be disabled. Before you
begin the full discharge, disable Hibernation. To disable
Hibernation:
1. Select Start > Control Panel > Performance and
Maintenance > Power Options > Hibernate tab.
2. Clear the Enable Hibernation check box.
3. Click Apply.
To fully discharge the battery pack:
1. Select the power icon on the taskbar or select Start >
Control Panel > Performance and Maintenance > Power
Options > Power Schemes tab.
2. Make a note of all settings in the Plugged In column and all
settings in the Running On Batteries column, so you can
reset them after calibration.
3. Use the lists to set each item in both columns to Never.
4. Select OK.
5. Disconnect the notebook from the external power source, but
do not turn off the notebook.
6. Run the notebook on battery power until the battery pack is
fully discharged. The battery light will blink when the
notebook has reached a low-battery condition. When the
battery pack is fully discharged, the battery light is turned off
and the notebook shuts down.
Hardware and Software Guide
Power
3–21