Table of Contents
Advertisement
Powering Off the Projector
1. Press "Power/Standby" to turn off the projector lamp. The projector will display
the message "Power off the lamp?"
2. Press "Power/Standby" again to confirm. Otherwise the message will disappear
after 5 seconds.
3. "Power/Standby" indicator will turn green for approximatly 90 seconds. When
the green light begins flashing, the projector has entered standby mode.
If you wish to turn the projector back on, you must wait until the projector has
completed the 90-second cooling cycle and has entered standby mode. Once in
standby mode, simply press "Power/Standby" to restart the projector.
4. Disconnect the power cord from the electrical outlet and the projector.
5. Do not turn on the projector immediately following a power off procedure.
If the "TEMP" indicator begins flashing the projector will display a "Fan
Fail" warning. After a short period the "Power/Standby" indicator will flash
green for about 90 seconds and the projector will automatically shut itself down.
If this occurs please contact your local reseller or service center.
If the "TEMP" indicator turns red it indicates the projector has overheated.
The projector will display "Over Temperature. After a short period the
"Power/Standby" indicator will turn green and the projector will
automatically shut itself down. If this occurs please contact your local
reseller or service center.
If the "LAMP" indicator turns red and the "Power/Standby" indicator
turns amber, the projector will automatically shut itself down. If this occurs
please contact your local reseller or service center.
Installation
E
nglish
13
Advertisement
Table of Contents
