Epson EMP-X56 User Manual page 30

List of Functions
Sub Menu
Operation Direct Power On: You can set whether Direct Power On is enabled (On) or disabled (Off).
When it is set to "On" and the projector power cable is connected to an electrical outlet, be aware that sudden surges of electricity may cause the
projector to turn on automatically.
Sleep Mode: When set to "On", this turns off the power automatically when no image signal is input and no operations are performed. Sleep
mode is set to (Off) at the time of purchase, so do not forget to turn off the power after projecting.
Sleep Mode Time: When Sleep Mode is set to "On", you can set how long the projector should wait before turning off the power from 1 to
30 minutes.
Lens Cover Timer: When set to "On", this turns off the power automatically 30 minutes after the lens cover is closed. Lens Cover Timer is set to
(On) at the time of purchase.
High Altitude Mode: Set this to "On" when using the projector above an altitude of 1500 m.
Standby Mode You can use network monitoring and control functions while the projector is in standby mode when this is set to "Network On".
(EMP-83/822 only)
You can use SNMP
this product.
Link 21L g You can set whether to use the utility software EMP Link 21L (On) or not (Off). Set this to "On" and use it after installing the USB
(EMP-X5/S5 only) communication driver.
Language You can set the language for message displays.
Reset You can reset "Display
To return all menu items to their default settings, see s
*1 When "User's Logo Protect" is set to "On" in "Password Protect", settings concerning user's logo cannot be changed. You can make changes after setting "User's
Logo Protect" to "Off". s
Depending on the area of purchase, the User's Logo function may not be available for EMP-X5/S5. In that case, "User's Logo" is not displayed.
*2 Except for "High Altitude Mode".
g
to monitor and control the status of the projector over the network, or by using the "EMP Monitor" software supplied with
*1 *2
" and "Operation " in the "Extended" menu to their default settings.
p.19
Function
p.35
30