HP Compaq Presario,Presario X1001 Maintenance And Service Manual page 116

Removal and Replacement Procedures
7. Lift the rear edge of the keyboard, swing it up and forward 1,
and rest it on the top cover.
8. Release the ZIF connector 2 to which the keyboard cable
is attached, and then disconnect the keyboard cable 3 from
the system board.
Disconnecting the Keyboard Cable
9. Remove the keyboard.
Reverse the above procedure to install the keyboard.
After the keyboard is removed, the internal memory mod ule
connector is accessible. Refer to
for instructions on removing the internal memory module.
5–18
Section 5.5, "Memory Module,"
Maintenance and Service Guide