Features At A Glance - Frigidaire Gallery LGID2475QF Use & Care Manual

FEATURES AT A GLANCE

Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms
against soiled surfaces. First, the dishwasher drains for a few seconds to remove soils dropped while
loading, then fi lls with water covering the fi lter area. Water is then pumped through the spray arms. Soil
particles go through and across the fi lter and down the drain as the water is pumped out. This series of
steps are repeated as needed. The number of water fi lls varies with the cycle being used.
Tub Gasket
Cup Shelves
Soft Grip
Rack
Middle Spray
Arm
Lower Rack
Lower Spray
Arm
Detergent
Dispenser
Rinse Aid
Dispenser
CAUTION
Property Damage Hazard
Before starting dishwasher be sure that the water
is connected and turned on. Failure to do so
may cause damage to the pump seal and result
in water leakage.
4
Features may vary according to model
Upper Spray Arm
Wash Cycle Selections
Cycle times are approximate and will vary with
options selected. Hot water is necessary to
activate dishwasher detergent and melt fatty food
soils. An automatic sensor will check the incoming
water temperature and, if it is not hot enough,
the cycle will be lengthened for automatic water
heating in the main wash and fi nal rinse of all
cycles. This happens even when HI-TEMP WASH
option has not be selected. When HI-TEMP WASH
is selected, an even higher temperature will be
reached to handle heavier soil loads.
Upper Rack
Flex Wash
Silverware
Basket
Filter
Serial Label
(located on right
side of door)