Fanimation Palisade FP240RS Owner's Manual page 7

2. Using the styrofoam pad provided, position one motor at
each end of the tube assembly. Securely attach plug from
motor to socket on tube assembly. (Figure 2)
3. Push assembled plug inside of tube assembly and slide
end of motor into tube assembly.
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the tube assembly
and not pinched between the motor assembly and the
tube assembly.
4. Align holes of tube with holes of motor assembly and
install three screws at each motor. Do not over-tighten.
(Figure 2)
5. Carefully lift the fan assembly and seat the extension
pole/hanger ball/horizontal tube assembly on the hanger
bracket that was just attached to the ceiling joist. Be sure
the groove in the ball is lined up with tab on the hanger
bracket. (Figure 3)
6. Attach the safety cable to ceiling support cable. Slide
cable clamp onto safety cable (from fan). Place the end
of cable through the loop of ceiling support cable. Pull as
much cable through loop as possible. Feed end of cable
into clamp hole and rmly tighten screw (Figure 3). Cut
off excess safety cable.
▲WARNING
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
Final Fan Assembly (continued)
Tab
▲WARNING
To avoid possible shock, do not pinch wires between the
adapter/hanger ball assembly and the hanger bracket.
7
Figure 2
Attach Safety
Cable to Ceiling
Support Cable
Downrod/Hanger
Ball Assembly
Figure 3