Password (Setting A Password); If You Forget Your Password - Sharp PG-A10X Operation Manual

Hide thumbs Also See for PG-A10X:
Table of Contents

Advertisement

Password
word)
A password must be set to activate the "Anti-Theft"
function (Page 48).
There is no factory preset for the password or the
"Anti-Theft" settings. In this way, anyone can freely
set a new password and "Anti-Theft" settings. It is
therefore recommended that even if you do not want
to use the "Anti-Theft" function, you at least set a
password to prevent others from setting the "Anti-
Theft" function.
A password can only be set by using the remote
control.
Select "Password" on the "Options" menu,
then press
low to enter the password.
1
' '
' ' or "
Press '
number and then press | | | | | .
2
Enter the 3 remaining digits and
press
3
Enter the password again in "Recon-
firm" and press
Note
• When a password is set, you need to enter the
password to change the "Anti-Theft" setting.
If you want to change the password, follow
the procedure below.
Downloaded from:
http://www.usersmanualguide.com/
(Setting a Pass-
and follow the procedure be-
" " to select the desired
" "
.
.
1
Press '
' ' , "
' '
" "
" " and | | | | | to enter the pass-
word in "Old Password" and press
.
2
' ' , "
' '
" " and | | | | | to set the new
" "
Press '
password and press
3
Enter the new 4-digit password
again in "Reconfirm" and press
.
Note
• If you do not want to set a password, leave the
fields in steps 2 and 3 blank and press
• To cancel the password settings, press
If You Forget Your Pass-
word
If you forget the password, delete it using the fol-
lowing procedure and set a new password.
Press
Note
• You can only use the buttons on the projector
to delete the password.
• The password cannot be deleted using the
above described procedures while the "Anti-
Theft" function is set. If you forget your pass-
word while the "Anti-Theft" function is activated,
you will need to contact your nearest Sharp Au-
thorized Projector Dealer or Service Center (see
page 65). You may need to bring your projector
to them to restore the projector to original fac-
tory condition (password and keycode reset).
.
.
.
-47

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pg-a10s

Table of Contents