Beko WUE7512XAW User Manual page 22

4.3.12 Starting the programme
1. Press Start/Pause button to start the programme.
2. Programme follow-up light showing the startup of the programme will turn on.
C
INFORMATION
• If no programme is started or no key is pressed within 10 minutes during the
programme selection process, the display lights will go off. Once the Programme
Selection knob is turned or any button is pressed, display lights will turn on again.
4.3.13 Progress of programme
Progress of a running programme can be followed from the Programme Follow-up indicator. At the beginning of
each programme step, the relevant indicator light will turn on.
C
INFORMATION
• If the "Anti-crease+" auxiliary function has been selected, "End" LED and "Anti-crease+"
LED will be on at the same time while this step is continuing.
• To end the programme while the "Anti-crease+" step is running, simply press any button or
turn the programme selection knob.
You can change the auxiliary functions, speed and temperature settings without stopping the programme flow while
the programme is running. To do this, the change you are going to make must be something that will be carried out
after the programme step that is running. If the change is not suitable, relevant lights will flash 3 times.
C
INFORMATION
• If the machine does not proceed to the spinning step, the Rinse Hold function might
be active or the automatic unbalanced load detection system might be activated due
to the unbalanced distribution of the laundry in the machine.
4.3.14 Loading door lock
There is a locking system on the loading door of the machine that prevents opening of the loading door in cases
when the water level is unsuitable.
Loading door light will start flashing when the machine is switched to Pause mode. The machine checks the level of
the water inside. If the level is suitable, the loading door light will turn off and the loading door can be opened within
1-2 minutes.
If the level is unsuitable, the loading door light will remain on and the loading door cannot be opened. If
you are obliged to open the loading door while the Loading Door light is on, you must cancel the current
programme. See "Cancelling the programme"
22 / EN
Washing Machine / User's Manual