Cutting Laminate - Xyron XRN4400 Instruction Manual

Cutting Material
To cut the material off after your document(s) have passed through the machine, please follow the
instructions below:
1. Place the document over the edge of the output side of the machine housing.
2. Using the handheld cutter [3351], place the cutter onto the edge of the material at the point you wish
to cut off the excess.
3. Pull material tight to apply tension to film when cutting
4. To cut the material, pull the blade along the edge of the machine to cut the material.
5. Apply force down the length of the material to full cut and separate the material from the supply roll.
6. Additional trimming of any excess laminate can now be done to your document.
Note: Cutting can be performed from either side of machine. Icon is provided to indicate the
recommended cutting area and direction.
Cutting direction on back of machine Apply tension to film when cutting
18