ICON Health & Fitness Pro-Form 750 RX User Manual page 13

For the most accurate heart rate reading, continue
to hold the handgrips for about 15 seconds. Note:
When you first hold the handgrips, the display will
show your heart rate continuously for 15 seconds.
The display will then show your heart rate along
with the other feedback modes.
When you are finished exercising, the console
6
will automatically turn off after a few minutes.
If the pedals are not moved and the console but-
tons are not pressed for a few minutes, the con-
sole will automatically turn off to conserve the
batteries.
HOW TO USE A PRESET PROGRAM
Turn on the console.
1
See step 1 on page 12.
Select one of the six preset programs.
2
Each time the
console is turned
on, the manual
mode will be
selected. To
select a preset
program, press
the Program but-
ton repeatedly until the number 1, 2, 3, 4, 5, or 6
appears in the upper right corner of the display.
The profiles on the right side of the console show
how the resistance of the elliptical crosstrainer
and the target pace will change during the pro-
grams. For example, profile number 3 shows that
during program 3, both the resistance and the tar-
get pace will gradually increase during the first
half of the program, and then decrease during the
last half.
All manuals and user guides at all-guides.com
13
Start the program.
3
To start the program, simply begin pedalling.
Each program consists of either twenty or thirty,
one-minute periods. One resistance setting and
one pace setting are programmed for each peri-
od. (The same resistance setting and/or pace set-
ting may be programmed for consecutive peri-
ods.)
During the program, the resistance of the elliptical
crosstrainer will automatically change as shown
by the applicable profile on the console. If the cur-
rent resistance level is too high or too low, you
can change the resistance level by pressing the +
and – buttons. However, when the current period
of the program is completed, the resistance level
will automatically change if a different resistance
setting is programmed for the next period.
The target pace
settings for the
program will be
shown by the
right pace indica-
tor in the display.
(The left indicator
will show your actual pedalling pace.) As the right
indicator changes in height during the program,
simply adjust your pace so that both indicators
are at the same height. If your pace is slower
than the current target pace, the increase arrow
will appear in the display to prompt you to
increase your pace; if your pace is faster than the
target pace, the decrease arrow will appear.
Important: The target pace settings for the
program are intended only to provide a goal.
Your actual pace may be slower than the tar-
get pace settings, especially during the first
few months of your exercise program. Make
sure to pedal at a pace that is comfortable for
you.
During the program, the display will show the time
remaining in the program. If you continue ped-
alling after the program is completed, the display
will continue to show your exercise feedback.
Increase Arrow